Preparation

Microfiber is excellent for cleaning walls and ceiling because it holds dirt and grime inside the Mop Pad, requires minimal water usage, therefore it does not drip.

The best scenario is to use an 18" Mop Holder and a Extendable 360 degree Swivel Handle which will give you better reach and control.

You will also need a GREEN 18" Dust Mop Pad and one 18" Blue Scrubbing Pad for approximately every 200 square feet  of wall or ceiling space to be washed (about a 14'x 14' area).

Start by DUSTING with the GREEN PAD. Use the paint roller theory to dust the area to be washed.

Now Your Ready to Wash! WET the BLUE PADS with clean water and Wring out the excess to prevent dripping.

For Ceilings start in a corner. Use long strokes in a continuous S pattern, overlapping slightly to insure coverage. Use your pad until it dries out or begins leaving streaks, then it is time to change the pad. When using Chemicals spray the damp mop pad.

On Walls start in a corner and use the continuous S pattern working horizontally left to right moving down the wall. Again, overlap slightly to insure coverage and use your pad until it dries out or begins leaving streaks, apply a fresh pad and continue as needed. When using Chemicals use the Spritz method to spray the wall first.

NOTE: Chemical cleaning solutions can be used.

Oban Cleaning Deodorizer used at 1/2 ounce per quart is exceptional at cleaning and eliminating organic odors such as smoke and mildew.

Clean by Peroxy 15 All Purpose Cleaner used at 1/2 ounce per quart will remove grease, oils and heavier dirt.

All FiberKraft Chemical products meet Green Seal Environmental Standards and are designed and engineered to work with FiberKraft Microfiber Products. See "About FiberKraft"